1. Panel door panel

Door panel technical parameters:

The thickness of the door panel is 40mm, the double layer is 0.5 thick coated steel plate, double-sided orange embossing, double-sided stripes. The middle is filled with fluorine-free high-density polyurethane and has a foaming density of 43 kg/m3. The door panel has the characteristics of heat preservation, heat insulation, sound insulation, no cracking, light fastness, anti-corrosion, no rust, no fading. Fluorine-free polyurethane is non-toxic and tasteless. The door panel is reinforced with a whole through-type steel strip at the hinge mounting position, and the joints of the door panels are sealed with rubber to cut off the heat transfer to reduce heat loss.

Thermal conductivity: 0.38 W/m ° C

Sound insulation: 24 dB

Wind pressure resistance: Class 3 (En13241-1 European standard) (anti-11 wind according to national standards)

Water tightness: 30 Pa

Unique door panel steel non-contact edge design

Exquisite door embossing process, beautiful, clear texture, smooth hand, optional color

According to the international common RAL color standard, you can configure any color, 8 standard colors:

2, Pioneer industrial door motor

The motor control box has buttons on the panel for on/off/off functions. The standard is turned on by three buttons. Other commonly used control functions are available as an option. The door opening speed is 0.15-0.2 m/s. The control system has a fault code display that does not require a chain guide for hand-to-electric conversion.

Drive power: three-phase AC 380V / two-phase 220V Frequency: 50 Hz

Rated power: 350W Rated current: 3.3 A

Rotational torque: 30 N/m Output speed: 24 rpm

Degree of protection (IP): 44 Operating ambient temperature: -20~+55°C

3. Rail track

The guide rail adopts hot-dip galvanized integrated semi-closed double-track guide rail with a thickness of 2mm; and the door body is sealed by an EPDM seal strip, and the rail connection is connected by bolts, and is fixed to the wall through the bracket and the reinforcing guard plate. The distance between the door and the wall can be adjusted, and the thickness of the galvanized layer is not less than 280 g/m2.

4. Hardware Parts

After tightening the self-tapping screws, there are three support points inside the door panel to prevent the self-tapping screws from loosening.
 

5. Balancing system

The lifting doors are balanced by a high-strength spring system consisting of a torsion spring shaft, a torsion spring, a snap-proof spring breaking device, a torsion spring bracket, a wire rope, and a head. The minimum service life is 50,000 cycles. The tower wheel is made of cast aluminum. Accurate calculation and selection of torsion springs according to size, configuration and track to ensure smooth, smooth opening and long service life

6. Seals seal

All lift doors are fitted with top and bottom seals, and the door panels (TPE thermoplastic rubber), side, bottom and top seals (EPDM DuPont EPDM) effectively prevent air and rain leakage, and all An imported EPDM seal is provided between the rail and the door panel to provide good airtightness between the door and the rail. EPDM sealing system is resistant to high and low temperatures, is not easy to age, and has a long service life.

7. Safety equipment---CE certification

The torsion spring breaking device, in the case of any spring break, the door will stop within 10cm; the wire rope anti-fracture safety device will catch the track when the wire suddenly breaks, so that the door body stops falling within 10cm; the airbag The protective device encounters an obstacle during the closing of the door, and the safety device will stop or reverse the door until it is fully open.